ChinaAutoRegs｜GB/T 3672.2-2002 英文版/English/翻译/橡胶制品的公差 第2部分：几何公差
Rubber–Tolerances of products–Part 2:geometrical tolerances

1 Scope
This Standard specifies the following geometrical tolerances for moulded and extruded solid rubber products, including those with metal inserts:
– flatness tolerance;
– parallelism tolerance;
– perpendicularity tolerance;
– coaxiality tolerance;
– positional tolerance.
The tolerances are primarily intended for use with vulcanized rubber but may also be suitable for products made of thermoplastic rubbers.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards listed below.
GB/T 2941-1991 Standard temperature, humidity and time for environmental regulation and testing of rubber samples (eqv ISO 471:1995)
GB/T 5723-1993 Rubber, vulcanized or thermoplastic－Determination of dimensions of test pieces and products for test purposes (eqv ISO 4648:1991)
GB/T 6031-1998 Rubber, vulcanized or thermoplastic — Determination of hardness (hardness between 10 IRHD and 100 IRHD) (idt ISO 48:1994)
ISO 1101:1983 Technical drawings-Geometrical tolerancing – Tolerancing of form, orientation, location and run-out-Generalities, definitions, symbols, indications on drawings
ISO 2230:1973 Vulcanized rubber — Guide to storage

***********************************************
现成译文，到款即发。
支持样页验证质量。免费提供增值税发票。
请联系 QQ: 564965870/微信: 13306496964/Email: standardtrans@foxmail.com 购买完整译文(PDF/Word)。
专业源于专注|ChinaAutoRegs 始终专注于机动车标准翻译！迄今为止已翻译上千个国内外汽车法规标准！独家打造千万级汽车专业术语库和记忆库。