ChinaAutoRegs｜GB/T 18487.1-2015 英文版/English/翻译/电动汽车传导充电系统 第1部分：通用要求
Electric Vehicle Conductive Charging System ―Part 1: General Requirements

GB/T 18487.1-2023英文版翻译《电动汽车传导充电系统 第1部分：通用要求》

1 SCOPE

This part of GB/T 18487 specifies classification, general requirements, communications, protection against electric shock, connection between EV and EV supply equipment (EVSE), special requirements for vehicle coupler, plug and socket-outlet, EV supply equipment constructional requirements, performance requirements, overload protection and short circuit protection, emergency disconnect, service conditions, repair, marking and instructions for electric vehicle conductive charging system.
This part applies to the EV supply equipment which provides off-board conductive charging for EV, e.g. AC charging spot, off-board charger and connection set for charging electric vehicle, etc., with a rated supply voltage up to 1,000 V AC or up to 1,500 V DC, and a rated output voltage up to 1,000 V AC or up to 1,500 V DC.
This standard also applies to EV supply equipment supplied from on-site storage systems (e.g. buffer batteries).
XXXX

2 NORMATIVE REFERENCES

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

GB 1002 Single Phase Plugs and Socket-outlets for Household and Similar Purposes – Types, Basic Parameters and Dimensions
GB 1003-2008 Three Phases Plugs and Socket-outlets for Household and Similar Purposes – Types, Basic Parameters and Dimensions
GB 2099.1 Plugs and Socket-outlets for Household and Similar Purposes – Part 1: General Requirements
GB 7251.1-2013 Low-voltage Switchgear and Controlgear Assemblies – Part 1: General Rules (IEC 61439-1:2011, IDT)
GB 10963.1-2005 Electrical Accessories – Circuit-breakers for Overcurrent Protection for Household and Similar Installation – Part 1: Circuit-breakers for AC Operation (IEC 60898-1:2002, IDT)
GB 14048.2-2008 Low-voltage Switchgear and Controlgear – Part 2: Circuit-breakers
GB 14048.3-2008 Low-voltage Switchgear and Controlgear – Part 3: Switches, Disconnectors, Switch-disconnectors and Fuse-combination Units (IEC 60947-3:2005, IDT)
GB/T 14048.4-2010 Low-voltage Switchgear and Controlgear – Part 4-1: Contactors and Motor-starters – Low-voltage Electromechanical Contactors and Motor Starters (including Motor Protector)
GB 16895.3-2004 Electrical Installations of Buildings – Part 5-54: Selection and Erection of Electrical Equipment – Earthing Arrangements, Protective Conductors and Protective Bonding Conductors (IEC 60364-5-54:2002, IDT)
GB 16916.1-2014 Residual Current Operated Circuit-breakers without Integral Overcurrent Protection for Household and Similar Uses (RCCB) – Part 1: General Rules (IEC 61008-1:2002, MOD)
GB/T 16935.1-2008 Insulation Coordination for Equipment within Low-voltage Systems – Part 1: Principles, Requirements and Tests (IEC 60664-1:2007, IDT)
GB/T 17045-2008 Protection against Electric Shock – Common Aspects for Installation and Equipment (IEC 61140:2001, IDT)
GB/T 19596-2004 Terminology of Electric Vehicles
GB/T 20234.1-2015 Connection Set of Conductive Charging for Electric Vehicles – Part 1: General Requirements
GB/T 20234.2-2015 Connection Set of Conductive Charging for Electric Vehicles – Part 2: AC Charging Coupler
GB/T 20234.3-2015 Connection Set of Conductive Charging for Electric Vehicles – Part 3: DC Charging Coupler
GB/T 21711.1-2008 Electromechanical Elementary Relays – Part 1: General and Safety Requirements (IEC 61810-1:2003.IDT)
GB 22794-2008 Type B Residual Current Operated Circuit-breakers with and without Integral Overcurrent Protection for Household and Similar Uses (Type B RCCBs and Type B RCBOs) (IEC 62423:2007, IDT)
GB/T 27930-2015 Communication Protocols between Off-board Conductive Charger and Battery Management System for Electric Vehicle
GB/T 28569-2012 Electric Energy Metering for Electric Vehicle AC Charging Spot
GB/T 29317-2012 Terminology of Electric Vehicle Charging/Battery Swap Infrastructure
GB/T 29318-2012 Electric Energy Metering for Electric Vehicle Off-board Charger
GB 50057-2010 Design Code for Protection of Structures against Lightning
IEC 60269 (All Parts) Low-Voltage Fuses
IEC 60898 (All Parts) Electrical Accessories – Circuit-Breakers for Overcurrent Protection for Household and Similar Installations
IEC 60947-6-2:2007 Low-Voltage Switchgear and Controlgear – Part 6-2: Multiple Function Equipment – Control and Protective Switching Devices (or Equipment) (CPS)
IEC 61009-1:2013 Residual Current Operated Circuit-Breakers with Integral Overcurrent Protection for Household and Similar Uses (RCBOs) – Part 1: General Rules
IEC 6185l-23 Electric Vehicle Conductive Charging System – Part 23: DC Electric Vehicle Charging Station
IEC 62477-1:2011 Safety Requirements for Power Electronic Converter Systems and Equipment – Part 1: General

1、现成译文，到款即发。
2、下单前可任取样页验证译文质量。
3、免费提供正规普通增值税数电发票。
4、请联系手机/微信: 13306496964/Email: standardtrans@foxmail.com 获取完整译文。
5、本英文译本为纯人工专业精翻版本，保证语法术语准确率和专业度！
6、专业源于专注|ChinaAutoRegs 始终专注于汽车标准翻译领域！
7、「中国汽车标准译文库」已收录上千个现行汽车国家标准和行业标准的英文版译本，涵盖传统燃油车、新能源汽车和摩托车标准化体系！独家打造千万级汽车专业术语库和记忆库。

1. The English Translation of this document is readily available, and delivered immediately upon payment.
2. You may request for sample pages to your preference before placing an order.
3. Please contact standardtrans@foxmail.com for the complete PDF version in English.
4. Almost all of Chinese automotive/automobile standards, regulations and norms (GB, GB/T, QC/T, CNCA, CQC, CAV, etc.) in effect have been included in our well-established database, providing one-stop, up-to-date, efficient and professional solution.